FAA OBSTRUCTION LIGHTS
P&R Tech offers a wide range of LED based obstruction lights that meet and exceed FAA and ICAO standards.
- LEDs typically use 1/12 the power of incandescent lamps.
- Our LEDs have a 5-year warranty & a 15-year typical operating lifetime.
- Far fewer failures & less relamping greatly reduce maintenance costs!
- Fewer high voltage components, less maintenance, and lower weight of LED lamps enhance the safety of equipment crews.
- LEDs are well suited to hazardous area lighting, including Class I, Div 2 and Class II, Div 2.
See the FAA Advisory
These steady red LED obstruction lights meet/exceed FAA & ICAO standards at a lower cost than the L-810 (below). IR option for night vision. Weather and corrosion resistant. 5 year warranty.
LED technology in a traditional 810 light. Meets or exceeds FAA & ICAO standards. Multiple voltages. Class I, Div 2 available. Blue, green, amber, white available. Weather and corrosion resistant. 5-year warranty.
This steady/flashing red LED beacon is the perfect solution for wind turbines, towers (cell/broadcast/other), buildings, and similar obstructions. IR option for night vision. Meets FAA requirements. Uses only 48W. 5-year warranty.
This 24/7 beacon features white flashing LEDs for visibility in daylight and red flashing LEDs for visibility at night. Meets FAA requirements. 5-year warranty, enhanced safety, little or no maintenance.
Same LED beacon as the L-864/865 (above), but with flashing set to 60 FPM and flashed in sequence to mark river crossings. 5-year warranty, enhanced safety, little or no maintenance.
Safe and low cost fixture focuses white LED light for Class I, Div 2 & Class II, Div 2 hazardous area lighting. This IP66-rated solid state design sharply reduces failures and relamping costs. 5-year warranty.
Innovative LED obstruction light and marker provides two steady red 32.5 candela lights powered off the conductor. Can mark towers or obstructions up to 150 feet high without another source of power.
