TowerLite
Self-Illuminated
Obstruction Lights
The patent pending TowerLite installs directly on powered lines next to monopoles to meet FAA & ICAO standards. The two LED obstruction lights draw power from the line. The spherical marker is made of aluminum and can be installed on powered lines rated up to 250° C (482° F) and 500KV.
SpanLite Data Sheet (PDF)(TowerLite puts both SpanLite red LED lights on top of the marker)
Applications
The FAA recommends the use of steady red lighted markers with a minimum intensity of 32.5 candela on transmission line catenary wires near airports, heliports, across rivers, canyons, lakes, etc. The lighted markers should be installed on the highest energized line. If they are installed on a lower line (not more than 20 ft. away from the highest line), 36" markers such as our SpanGuard markers should be installed on the highest line. See the FAA Marker Advisory.
TowerLite is based on our industry standard SpanGuard aluminum power line markers, but adds two red LED lights on top of the spherical marker to meet FAA and ICAO standards. It mounts directly to live line adjacent to the monopole and draws power from the line.
LED Obstruction Lights
The two sealed, steady red LED obstruction lights used in TowerLite require 50 Amps (2,000 Amps maximum) to continuously generate 32.5 candela each. No separate power source is needed, making TowerLite well suited to remote locations where costly and less reliable solar installations might otherwise be needed. The LED technology ensures a long operating life of many years with little or no maintenance. Flashing LED lights and other colors are available.
High Temp & Voltage Rating
TowerLite markers are rated up to 250° C (482° F) and 500KV on ACSS lines, where plastic or fiberglass markers can melt or burn. Made from aluminum, the 12" diameter TowerLite is also lightweight, weighing just 26 pounds.
TowerLite Installation
TowerLite markers are straightforward to install. The lower half of the marker is installed on the line first, then the upper half is attached. The conductor runs directly through the center of the marker and the internal transformer. Rugged clamps hold the TowerLite in place. To further protect the line, spiral preform armor rods are recommended under the clamps.
Ordering Information
| TowerLite Marker Models | ||
|---|---|---|
| Model | Diameter | Weight (w/o rods) |
| TL12 | 12" | 26 lbs. |
Ordering Instructions
1. Give Model Number and Color of markers.2. Give type and size of line, diameter of line, copper or aluminum.
3. Terms are Net 30.
4. FOB Roseburg, Oregon.
