Inverters
P&R Technologies
carries the largest selection and range of
inverters. Brands we carry include:
Information about
Inverters
Inverters change
Direct Current (DC) to Alternating Current (AC).
Stand-alone inverters can be used to convert DC from
a battery to AC to run electronic equipment, motors,
appliances, etc. Intertie Inverters are used to
convert the DC output of a photovoltaic module, a
wind generator or a fuel cell to AC power to be sold
to the utility grid. Multifunction inverters perform
both functions.
Stand-Alone
Inverters
Stand-alone inverters
convert DC power stored in batteries to AC power
that can be used as needed. Selecting an inverter
for your power system based on the maximum load you
will be powering, the maximum surge required, output
voltage required, input battery voltage and optional
features needed. High quality stand-alone inverters
are available in sizes from 100 watts, for powering
notebook computers and fax machines from your car,
to 500,000 watts, for powering a commercial
operation. The size of an inverter is measured by
its maximum continuous output in watts. T
his rating
must be larger than the total wattage of all of the
AC loads you plan to run at one time. The size of
the inverter can be minimized if the number and size
of the AC loads is kept under control. Wattage of
most AC loads can be determined from a tag or label
on the appliance, usually located near where the
power cord enters, or from the owner’s manual. If
the inverter is expected to run induction motors,
like the ones found in automatic washers, dryers,
dishwashers and large power tools, it must be
designed to surge, or deliver power many times its
rating for short periods of time while these motors
start.
Stand-alone inverters
are available with three basic power output
waveforms: square wave, modified square wave (often
called modified sine wave) and sine wave.
Utility-tie inverters and utility companies deliver
a sine wave. Square wave inverters have the lowest
cost and efficiency and are not sold in this
catalog. The price of the better quality inverters
is low enough to make square wave inverters an
unattractive choice.
Trace UX series, DR
series, U series inverters and Genius inverters have
modified square wave output with harmonic distortion
of around 40%. They are an economical choice in
power systems where waveform is not critical. Their
high surge capacity allows them to start large
motors while their high efficiency makes them
economical with power when running small loads like
a stereo or a small light. They can power most
lighting, televisions, appliances and computers very
well. We do not recommend them for computer systems
with laser printers.
Unfortunately, this
type of inverter may destroy some low cost
rechargeable tools and flashlights, and their
waveform will not allow many laser printers,
copiers, light dimmers and some variable speed tools
to operate. Equipment with silicon controlled
rectifiers or SCRs will not operate. Some audio
equipment will have a background buzz that may be
annoying to music connoisseurs.
Sine wave inverters
have a slightly higher cost, but they can operate
almost anything that can be operated on utility
power. Studer Inverters are available in sizes from
200 to 800 Watts. These are fantastic inverters for
remote cabins or smaller power needs. Trace Sine
wave inverters are available in sizes from 2500
watts to 5500 watts, and a pair of them can be
synchronized to deliver up to 11,000 watts. They are
an excellent choice for a ‘whole house" inverter.
Exeltech sine wave inverters, available in sizes
from 150 watts to 5000 watts, are an excellent
choice for power systems running audio or
telecommunications equipment and other electronics
that are waveform-sensitive. Larger Sine wave
inverters are available in sizes up to 500,000 watts
that can run a small village.
Utility-tie
Inverters
Utility inverters
change DC power into AC power to be fed into the
utility grid. A power system with this type of
inverter uses the utility company as a storage
battery. When the sun is shining, your electricity
comes from the PV array, via the inverter. If the PV
array is making more power than you are using, the
excess is sold to the utility (power company)
through an electric meter. If you use more power
than the PV array can supply, the utility makes up
the difference. This type of system makes the most
sense if you have utility power, because there are
no batteries to maintain or replace, but it has a
very long payback period and may not be
cost-effective at today’s electric rates. The SMA
Sunny Boy's, Trace SunTie, and AEI inverters are
examples of utility tie inverters.
Multifunction
Inverters
Trace Engineering
Company produces a line of sine wave inverters
called the SW line that can operate as a stand-alone
inverter and as an intertie inverter at the same
time. In a typical installation, the Trace SW
inverter is connected to a battery bank, the utility
power lines, a standby generator and the house load
center. When batteries are in a charged condition,
the SW inverter supplies AC power to the house from
the batteries. If the batteries become discharged,
the inverter supplies the house loads from the
utility lines, while charging the batteries. If the
batteries become fully charged by another power
source, such as photovoltaic modules or a wind or
hydroelectric generator, excess power may be sold
back to the utility. If utility power fails, the
inverter can still operate, supplying critical
loads. If a standby generator is started, it can
also supply power to loads. The inverter will
synchronize to the generator and allow loads to be
powered that are too large for either the generator
or inverter to supply alone. Multifunction inverters
are not the most efficient intertie inverters
because the system must have a battery, but they
allow system flexibility that intertie inverters do
not.
Output Voltage
We sell inverters that
supply standard 120 Volt 60 HZ AC power, such as one
gets from utility companies and fuel-powered
generators. Most of them can be special ordered with
other output voltages and frequencies for use
anywhere in the world. Please contact us with any
special requirements that you have.
Interference
The electronic
circuitry in some inverters may, in some cases,
cause problems with radio and television reception,
noise on telephones and buzz in audio equipment.
Sine wave inverters cause the least amount of
interference. Interference can be minimized by
locating the inverter very close to the batteries,
twisting together the cables that connect the
inverter to the battery, running AC lines separate
from other wiring (such as telephone wires) and
locating the inverter away from appliances that are
susceptible to interference. All inverters cause
interference on AM radio!